MESHPUNKDOCS

DRAFT: Kenton has not reviewed this page yet. Items in [brackets] still need his details.

How to build the k10n DIY

The k10n DIY is the same node as the k10n Mobile, sent as a kit for you to assemble.

How it’s laid out

The k10n is two halves.

  • The base. A black tray with magnets underneath. It holds the battery and sticks to your roof.
  • The shell. The 3D printed case. It holds the radio board in the Hug to Death cradle, with the solar panel as the lid and the antenna connector at one corner.

A printed clip on each side pulls the two halves together.

What’s in the kit

Part Notes
RAK19003 base board with RAK4631 The radio. [Confirm it is in every kit]
Printed shell with Hug to Death cradle Printed to order
Solar panel Reclaimed. Forms the lid
Magnetic base Reclaimed, magnets fitted
Battery Reclaimed. [Capacity]
Antenna and pigtail [Antenna type and connector]
Side clips and screws [Count and screw size]
[Anything else in the bag]  

What you need

  • An Allen key, [size]
  • [Small screwdriver, soldering iron, or anything else the build needs]

Steps

  1. Seat the board in the cradle. [How the RAK board goes into the Hug to Death cradle and which way it faces.]
  2. Connect the antenna pigtail. Press the pigtail onto the board’s LoRa connector until it clicks. The cradle holds it in place, so no glue is needed.
  3. Fit the antenna connector. [How the connector mounts in the corner of the shell.]
  4. Connect the solar panel. [Which plug goes where.]
  5. Connect the battery. [Which plug goes where, and any polarity warning.]
  6. Close it up. Set the shell on the base, slide a clip onto each side, and tighten the screws with the Allen key. Snug is enough. The clips are printed plastic.
  7. Screw on the antenna before you power it for the first time.

[Step photos go here. One per step works well.]

Flash and set up

[Whether the board comes flashed, or how to flash Meshtastic or MeshCore.]

Then follow Getting started from step 3.

Stuck?

Message Meshpunk through the Etsy shop.